A&D AD-8922A Manual de Instruções descarregar pdf (Página 8)

３ GETTING READY

３-１ Setting the Weighing Instrument and the AD-8922A

1. Set each item as shown below. Set the same value for the weighing instrument and the AD-8922A.

Table 3

Item Weighing instrument AD-8922A

Baud rate 600, 1200, 2400, 4800, 9600. 19200 bps

Data bits, Parity bit 7 bits - EVEN, 7 bits - ODD, 8 bits - NONE

Stop bits 1 bit or 2 bits

Terminator <CR> or <CR><LF>

Data format A&D standard format

⎯

Communication control No RTS/CTS control

⎯

Data output mode Stream mode*

⎯

Items in bold face type: Factory settings for both the AD-8922A and the weighing instrument.

* When connected to an external device, the settings can be changed to suit the use.

2. Set the command set "C5et" of the function setting, appropriate to the weighing instrument. See Table 2

in "1-2 Applicable Instruments".

Note: Some items may not be available for the instrument used. For details on setting, refer to

the instruction manual of each weighing instrument.

When connected to an external device such as a personal computer or a printer, set the output

mode "

out" and time out "Hold" of the function setting, and set the data output mode of the

weighing instrument, appropriate to the use. (See Table 3 in "3-5 Example of Use".)

３-２ Connecting the AD-8922A

For information on cables required for connection, see Table 1 in " 1-2 Applicable Instruments".

Connect the weighing instrument to the AD-8922A D-Sub 9-pin connector.

Connect an external device such as a personal computer or a printer to the AD-8922A DIN 8-pin

connector.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 41 42

Sem comentários

A&D AD-8922A Manual de Instruções Página 8