A&D OP-05 Especificações descarregar pdf (Página 16)

4-2 CONFIRMATION OF OPERATIONS

The following outlines the procedure up to displaying a weight value in order to confirm operations after unpacking.

Connect a load cell or load cell simulator to the proper terminals on the rear of the indicator.

TURNING ON THE POWER

* Do load cell wiring before turning on the power.

If the power is turned on in the normal mode, the display unit will be fully illuminated for about 2 seconds, and then, a

weight value will be displayed in the main display section. A weight value may not be displayed if calibration has not been

performed yet.

When only a circle (O) is displayed in the unit display section, the indicator is in the OFF mode. Press the [OPR/STB]

key.

CALIBRATION

The following outlines on how to calibrate the indicator. For details, see Chapter 5.

Step 1 Remove the cover from the calibration switch located at the lower left of the front panel and press the

[CAL] key (found inside). “CAL” is displayed to inform you that the indicator is entering the calibration

mode.

Note: When calibration is not required, press the [ESC] key and the indicator will return to the normal mode.

Step 2 Press the [ENTER] key. The indicator has entered the calibration mode and “CAL SEt” is displayed.

The right most digit starts blinking.

Step 3 To select the desired operation, use the [ ∧ ] or [ ∨ ] key, Press the [ ∧ ] key, “CAL Fnc” is displayed.

Step 4 Press the [ENTER] key. The indicator enters the calibration related function mode. The main display

section displays “CALF-01” and the sub-display section displays its set value. CALF-01 indicates the

setting of the unit.

Step 5 Select the function number you want to set, using the [ ∧ ] or [ ∨ ] key. The lower display section displays

the set value for the selected function. CALF-02 indicates the setting of a decimal point position.

Step 6 In this example, you change the decimal point position to the 10

digit. Press the [ENTER] key. The

Subdisplay section now starts blinking.

Step 7 Press the [ ∧ ] key. The Subdisplay section displays “1”.

Step 8 Press the [ENTER] key. The main display section starts blinking again and you are returned to Step 5,

the selection of a function number.

Step 9 Press the [ESC] key. The main display section starts blinking again and the settings so far are saved in

the EEPROM.

This state is the same as in Step 3. Press the [ESC] key again twice. The indicator will return to the

normal mode.

Step 10 Subsequently, calibrate with an actual load. Press the [ENTER] key. The main display section displays

“CAL 0.”

Step 11 With no weight placed on the system and press the [ENTER] key after the motion-detect mark is turned

off. The Subdisplay section displays “——” for about 2 seconds.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 89 90

Sem comentários

A&D OP-05 Especificações Página 16