A&D AD-4430B Especificações descarregar pdf (Página 42)

- 40 - AD-4430B

7.4. Initializing Parameters

The initialization mode restores the parameters of the default values to the FRAM.

Three types of initialization mode are available as shown below.

Initialization mode Display Description

RAM

initialization

RAM memory is initialized. The center of zero and tare

value will be restored to 0.

General functions

initialization

Data of the general functions stored in the FRAM are

reset to factor settings.

All data

initialization

All data stored in the FRAM are initialized. So calibration

data is included, calibrate the module again.

7.4.1. Initializing Mode For RAM And Function Parameters

Step 1 Press the key while pressing and holding the key ( + ) to

display . If returning to the weighing mode, press the key.

Step 2 Press the

key while pressing and holding the key (

+ ) to

display of the check mode.

Step 3 Select the initialization mode using the key. Press the key.

Step 4 Select an item to be initialized using the key. Press the key.

Step 5 Check that all status LED are blinking.

If performing the initialization, press the key for 3 seconds or more.

After initialization, all segments light and return to the weighing mode.

If canceling the initialization, press the key return to the weighing mode.

7.4.2. Initializing The Whole Data

Step 1 In the standby mode (While turning off the module),

Press + key to display .

If returning to the weighing mode, press the key.

Step 2 Press the key. to enter to calibration mode.

Step 3 Select all initialization mode using the key. Press the key.

Step 4 Check that all status LED are blinking.

If performing the initialization, press the key for 3 seconds or more.

After initialization, all segments light and return to the weighing mode.

If canceling the initialization, press the key return to the weighing mode.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 55 56

Sem comentários

A&D AD-4430B Especificações Página 42