A&D OP-11 Manual de Instalação descarregar pdf (Página 97)

07/2011 2 Operating A&D DataManagement

2.5 HD component

SIMATIC A&D DataManagement Client - 07/2011

2-97

− Under "Network adapter detection mode" you enter whether the

network driver should be displayed again when the disk is

rebooted and this profile is used (Prompt), whether auto-detection

should be started immediately (Auto), whether the list of available

drivers should be displayed (Manual) or whether the previously

selected driver should be used automatically (here: NE2000).

− If there is a cross next to "Skip TCP/IP settings", this dialog is not

displayed and the saved values are automatically used.

The same applies to "Skip identification dialog".

− Due to the fact that it is saved as plain text, "Save password" can

pose a security risk, but is available as an option.

− In the "Timeout" dialog you can enter the amount of time after

which the entry dialogs should be automatically closed.

− The write protection message, which you will already be familiar

with from the keyboard code, is then displayed.A few more settings

are then applied to the profile.

12. Return to the identification settings and confirm with "OK". The network is

then initialized and, when everything has been started correctly, the

password for setting the ADDM shares is requested.

13. Finally, Ghost is started and the desired action (backup or load) is

performed.

After Ghost is completed, a prompt is displayed and the computer can be

restarted or controlled from the DOS Prompt.

Note

If something needs to be changed on the boot disk (in particular msnet), or a

separate network boot disk needs to be used, the following commands must be

executed after the network is set up:

net\net logon %p_addmuser% /savepw:no

net\net use x: \\%p_addmserver%\ADDMHDSHARE

x:\ADDM.bat

The "net" command must be available in the directory of the current drive, as it is

also accessed via this path in the ADDM.bat batch file generated by ADDM.

Therefore it is also important that this batch file is executed by the drive with

net\net via the x:\ADDM.bat command!

Comments

• During setup, all network drivers are copied from drivers\network (around

1.5 MB). Further network drivers can be added to this directory provided

that these are packaged as CAB files and, along with the DOS driver

(.dos), contain an .ini file, an ndis.pci and an ndis.txt file (see existing

drivers).

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 181 182

Comentários a estes Manuais

Sem comentários

A&D OP-11 Manual de Instalação Página 97

Comentários a estes Manuais

Manuais e produtos relacionados com Medição, teste e controlo A&D OP-11